Match Ip Route-Source - Dell Force10 Z9000 Reference Manual

Parameters
prefix-list
list-name
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands
match ip address

match ip route-source

match metric
match route-type
match tag
match ip route-source
Configure a filter to match based on the routes advertised by routes specified in IP access lists or IP prefix lists.
C-Series, E-Series, S-Series, Z-Series
Syntax match ip route-source {prefix-list prefix-list-name}
To delete a match, use the no match ip route-source {prefix-list prefix-
list-name} command.
Parameters
prefix-list
list-name
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.8.1.0
288
prefix-
Enter the keywords prefix-list and then enter the name of
configured prefix list, up 10 140 characters.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– redistributes routes that match the next-hop interface.
– redistributes routes that match an IP address.
– redistributes routes that match routes advertised by other routers.
– redistributes routes that match a specific metric.
– redistributes routes that match a route type.
– redistributes routes that match a specific tag.
prefix-
Enter the keywords prefix-list and then enter the name of
configured prefix list, up to 140 characters.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.