Show Ip Traffic - Dell Force10 Z9000 Reference Manual

Column Heading
Route Source
Active Routes
Non-active Routes
ospf 100
Total 1388 active...
Example
FTOS>show ip route summary
Route Source
connected
static
ospf 100
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
FTOS>
Related
show ip route
Commands

show ip traffic

View IP, ICMP, UDP, TCP and ARP traffic statistics.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip traffic [all | cp | rp1 | rp2]
Parameters
all
cp
rp1
Description
Identifies how the route is configured in FTOS.
Identifies the best route if a route is learned from two protocol
sources.
Identifies the back-up routes when a route is learned by two
different protocols. If the best route or active route goes down, the
non-active route becomes the best route.
If routing protocols (OSPF, RIP) are configured and routes are
advertised, then information on those routes is displayed.
Displays the number of active and non-active routes and the memory
usage of those routes. If there are no routes configured in the FTOS,
this line does not appear.
Active Routes
17
3
1368
1388
– displays information about the routes found in the switch.
NOTE: These options are supported only on the E-Series.
(OPTIONAL) Enter the keyword all to view statistics from all
processors. If you do not enter a keyword, you also view all statistics
from all processors.
(OPTIONAL) Enter the keyword cp to view only statistics from the
Control Processor.
(OPTIONAL) Enter the keyword rp1 to view only the statistics from
Route Processor 1.
Non-active Routes
0
0
2
2
827