Debug Bfd - Dell Force10 Z9000 Reference Manual

debug bfd

Enable BFD debugging.
C-Series, E-Series
Syntax debug bfd {detail | event | packet} {all | interface} [mode]
[count number]
Parameters
detail
event
packet
all
interface
mode
count
(OPTIONAL) Enter the keyword detail to display detailed
information about BFD packets.
(OPTIONAL) Enter the keyword event to display information about
BFD state. The mode option is not available with this option.
(OPTIONAL) Enter the keyword packet to display brief information
about control packets.
Enter the keyword all to enable debugging on all interfaces. The
count option is not available with this option.
(OPTIONAL) Enter one of the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet and then enter the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet and then enter the slot/port
information.
• For a SONET interface, enter the keyword sonet and then
enter the slot/port information.
• For a port-channel interface, enter the keyword port-
channel and then enter a number. For the C-Series, the
range is 1 to 128. For the E-Series, the range is 1 to 255 for
TeraScale and 1 to 512 for ExaScale.
• For VLAN interfaces, enter the keyword vlan and then enter
a number from 1 to 4094. For ExaScale VLAN interfaces, the
range is 1 to 2730 (VLAN IDs can be 0 to 4093).
(OPTIONAL) Enter one of the following debug transmission modes:
• Enter the keyword both to display information for both
received and sent packets.
• Enter the keyword rx to display information for received
packets.
• Enter the keyword tx to display information for sent packets.
The default is both.
number
(OPTIONAL) Enter the keywords count number followed by the
number of debug messages to display. The range is 1 to 65534. The
default is Infinite—that is, if a count number is not specified, an
infinite number of debug messages display.
319