Seq Ether-Type - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)
Hide thumbs Also See for Force10 Z9000:
Table of Contents

Advertisement

Command History
Version 8.2.1.0
Version 8.1.1.0
Version 7.4.1.0
Version 6.5.10
Usage
The monitor option is relevant in the context of flow-based monitoring only. For more
Information
information, refer to
The order option is relevant in the context of the Policy QoS feature only. The following
applies:
When you use the log option, the CP processor logs details about the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets' details.
You cannot include IP, TCP, or UDP (Layer 3) filters in an ACL configured with ARP or Ether-
type (Layer 2) filters. Apply Layer 2 ACLs to interfaces in Layer 2 mode.

seq ether-type

Configure an egress filter with a specific sequence number that filters traffic with specified types of Ethernet packets.
This command is supported only on 12-port GE line cards with SFP optics. For specifications, refer to your line card
documentation.
E-Series
Syntax
seq sequence-number {deny | permit} ether-type protocol-type-
number {destination-mac-address mac-address-mask | any} vlan
vlan-id {source-mac-address mac-address-mask | any} [count
[byte] | log] [order] [monitor]
To remove this filter, use the no seq
Parameters
sequence-
number
deny
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on the E-Series ExaScale.
Added the monitor option.
Expanded to include the optional QoS order priority for the ACL
entry.
Port
Monitoring.
The seq sequence-number command is applicable only in an ACL group.
The order option works across ACL groups that have been applied on an interface
via the QoS policy framework.
The order option takes precedence over seq sequence-number.
If sequence-number is not configured, the rules with the same order value are
ordered according to their configuration order.
If sequence-number is configured, the sequence-number is used as a tie breaker
for rules with the same order.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
Enter a number from 0 to 4294967290.
Enter the keyword deny to drop all traffic meeting the filter criteria..
sequence-number command.
257

Advertisement

Table of Contents
loading

Table of Contents