Untagged - Dell Force10 Z9000 Reference Manual

Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
When this command is configured, the VLAN is operationally UP if any of the interfaces
Information
specified in the track ip command are operationally UP, and the VLAN is operationally
DOWN if none of the tracking interfaces are operationally UP.
If the track ip command is not configured, the VLAN's Layer 3 operational state depends
on all the members of the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the track ip
command configuration.
Related
interface vlan
Commands
tagged

untagged

Add a Layer 2 interface to a VLAN as an untagged interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface
command.
Parameters
interface
948
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– configures a VLAN.
– specifies which interfaces in a VLAN are tagged.
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.