Clear Ip Fib Stack-Unit - Dell Force10 Z9000 Reference Manual

Command History
Version 8.1.1.2
Version 8.1.1.0
Version 7.9.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage Use this command to clear Layer 3 CAM inconsistencies.
Information
Related show ip fib linecard
Commands

clear ip fib stack-unit

Clear all FIB entries in the specified stack unit (use this command with caution, refer to
S-Series, Z-Series
Syntax clear ip fib stack-unit unit-number
Parameters
unit-number
Command Modes EXEC
Command History
9.0.0.0
Usage Use this command to clear Layer 3 CAM inconsistencies.
Information
Related show ip fib stack-unit
Commands
Introduced on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the C-Series.
Introduced on the E-Series.
CAUTION: Executing this command causes traffic disruption.
– shows FIB entries.
Enter the number of the stack unit.
The range is 0 to 7.
Introduced on the Z9000.
CAUTION: Executing this command causes traffic disruption.
– Shows FIB entries on a specified stack-unit.
Usage Information below.)
775