Lsp-Gen-Interval - Dell Force10 Z9000 Reference Manual

lsp-gen-interval

Set the minimum interval between successive generations of link-state packets (LSPs).
E-Series, S4810
Syntax lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l | level-2]
interval seconds [initial_wait_interval seconds
[second_wait_interval seconds]] command.
Parameters
level-l
level-2
interval seconds
initial_wait_interv
al seconds
second_wait_inte
rval seconds
Defaults Refer to Parameters.
Command Modes ROUTER ISIS
Command History
Version 8.3.12.0
Version 7.5.1.0
Usage
LSP throttling slows down the frequency at which LSPs are generated during network
Information
instability. Even though throttling LSP generations slows down network convergence, no
throttling can result in a network not functioning as expected. If network topology is unstable,
throttling slows down the scheduling of LSP generations until the topology regains its stability.
The first generation is controlled by the initial wait interval and the second generation is
controlled by the second wait interval. Each subsequent wait interval is twice as long as the
previous one until the wait interval reaches the maximum wait time specified (interval
seconds). After the network calms down and there are no triggers for two times the
maximum interval, fast behavior is restored (the initial wait time).
(OPTIONAL) Enter the keywords level-1 to apply the configuration
to generation of Level-1 LSPs.
(OPTIONAL) Enter the keywords level-2 to apply the configuration
to generation of Level-2 LSPs.
Enter the maximum number of seconds between LSP generations.
The range is 0 to 120 seconds. The default is 5 seconds.
(OPTIONAL) Enter the initial wait time, in seconds, before running the
first LSP generation. The range is 0 to 120 seconds. The default is 1
second.
(OPTIONAL) Enter the wait interval, in seconds, between the first and
second LSP generation. The range is 0 to 120 seconds. The default is
5 seconds.
Introduced on the S4810.
Added support for LSP Throttling Enhancement.
883