Restrict-Flooding; Show Ip Mroute - Dell Force10 Z9000 Reference Manual

restrict-flooding

Prevent Layer 2 multicast traffic from being flooded on ports below a specified link speed.
E-Series TeraScale
Syntax restrict-flooding multicast min-speed min-speed
Parameters
min-speed
speed
Defaults none
Command Modes INTERFACE VLAN
Command History
Version 7.7.1.0
Usage
This command restricts flooding for all unknown multicast traffic on ports below a certain
Information
speed. If you want some multicast traffic to be flooded on slower ports, use the mac-flood-
list command without the min-speed option, in combination with restrict-flooding. With
mac-flood-list, you specify the traffic you want to be flooded using a MAC address
range.
You may not use the unicast MAC addresses when specifying MAC address ranges (do not
overlap MAC addresses ranges) when creating multiple mac-flood-list entries for the
same VLAN. Restricted Layer 2 flooding is not compatible with MAC accounting or VMANs.
Related mac-flood-list
Commands

show ip mroute

View the multicast routing table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip mroute [static | group-address [source-address] |
active [rate] | count | snooping [vlan vlan-id] [group-address
[source-address]] | summary]
Parameters
static
group-address
[ source-address ]
min-
Enter the minimum link speed that a port must have to receive flooded
multicast traffic. The range is 1000.
Introduced on the E-Series TeraScale.
– floods multicast frames with specified MAC addresses to all ports in a VLAN.
(OPTIONAL) Enter the keyword static to view static multicast
routes.
(OPTIONAL) Enter the multicast group-address to view only routes
associated with that group.
Enter the source-address to view routes with that group-address and
source-address.
1015