Dell Force10 Z9000 Reference Manual page 141

linecard
rp1
rp2
Defaults all
Command Modes EXEC
Command History
Version 8.3.11.1
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
Usage Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is
Information displayed first. All CPU and port information is displayed unless a specific port or CPU is
specified. Traffic information is displayed for router ports only; not for management interfaces.
The traffic statistics are collected only after the debug cpu-traffic-stats command is
executed; not from the system bootup.
Example
FTOS#show cpu-traffic-stats
Processor : CP
--------------
Received 100% traffic on GigabitEthernet 8/2 Total packets:100
LLC:0, SNAP:0, IP:100, ARP:0, other:0
Unicast:100, Multicast:0, Broadcast:0
Processor : RP1
---------------
Received 62% traffic on GigabitEthernet 8/2 Total packets:500
LLC:0, SNAP:0, IP:500, ARP:0, other:0
Unicast:500, Multicast:0, Broadcast:0
Received 37% traffic on GigabitEthernet 8/1 Total packets:300
LLC:0, SNAP:0, IP:300, ARP:0, other:0
Unicast:300, Multicast:0, Broadcast:0
Processor : RP2
---------------
No CPU traffic statistics.
FTOS#
NOTE: This option is supported on the E-Series only.
(OPTIONAL) Enter the keyword linecard followed by either all or
the slot number to display traffic statistics on the designated line
card.
NOTE: This option is supported on the C-Series only.
(OPTIONAL) Enter the keyword rp1 to display traffic statistics on the
RP1.
NOTE: This option is supported on the E-Series only.
(OPTIONAL) Enter the keyword rp2 to display traffic statistics on the
RP2.
NOTE: This option is supported on the E-Series only.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series
Introduced on the E-Series.
NOTE: After debugging is complete, use the no debug cpu-traffic-stats
command to shut off traffic statistics collection.
141