Interface Range Macro Name - Dell Force10 Z9000 Reference Manual

pre-Version
6.1.1.0
Example (Single
This example shows how to define an interface range macro named test. Execute the show
Range)
running-config command to display the macro definition.
FTOS(config)# define interface-range test
tengigabitethernet0/0-3,
gigabitethernet 5/0-47, gigabitethernet 13/0-89
FTOS# show running-config | grep define
define interface-range test tengigabitethernet0/0-3,
gigabitethernet5/0-47,
gigabitethernet 13/0 - 89
FTOS(config)#interface range macro test
FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
Related
interface range
Commands

interface range macro name

interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
C-Series, E-Series, S-Series, Z-Series
Syntax interface range macro name
Parameters
name
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.0
Example (Single
This example shows the macro named
Range)
FTOS(config)#interface range macro test
FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
FTOS
Related
interface range
Commands
706
Introduced on the E-Series.
– configures a range of command (bulk configuration)
– runs an interface range macro.
Enter the name of an existing macro.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
test that was defined earlier.
– configures a range of command (bulk configuration).