Isis Network Point-To-Point; Isis Password - Dell Force10 Z9000 Reference Manual

isis network point-to-point

Enable the software to treat a broadcast interface as a point-to-point interface.
E-Series, S4810
Syntax isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command History
Version 8.3.12.0

isis password

Configure an authentication password for an interface.
E-Series, S4810
Syntax isis password [hmac-md5] password [level-1 | level-2]
To delete a password, use the no isis password [password] [level-1 |
level-2] command.
Parameters
encryption-type
hmac-md5
password
level-1
level-2
Defaults No default password. level-1 (if not otherwise specified).
Command Modes INTERFACE
Command History
Version 8.3.12.0
Usage
To protect your network from unauthorized access, use this command to prevent unauthorized
Information
routers from forming adjacencies.
880
Introduced on the S4810.
(OPTIONAL) Enter 7 to encrypt the password using DES.
(OPTIONAL) Enter the keywords hmac-md5 to encrypt the password
using MD5.
Assign the interface authentication password.
(OPTIONAL) Independently configures the authentication password
for Level 1. The router acts as a station router for Level 1 routing. This
is the default.
(OPTIONAL) Independently configures the authentication password
for Level 2. The router acts as an area router for Level 2 routing.
Introduced on the S4810.