Isis Bfd All-Neighbors - Dell Force10 Z9000 Reference Manual

Command Modes CONFIGURATION
Command History
Version 8.2.1.0
Version 7.6.1.0
Version 7.4.1.0
Related show bfd neighbors
Commands interface.

isis bfd all-neighbors

Enable BFD on all IS-IS neighbors discovered on an interface.
E-Series, Z-Series, S4810
Syntax isis bfd all-neighbors [disable | [interval interval min_rx
min_rx multiplier value role {active | passive}]]
To remove all BFD sessions with IS-IS neighbors discovered on this interface, use the no
isis bfd all-neighbors [disable | [interval interval min_rx
min_rx multiplier value role {active | passive}]] command.
Parameters
disable
interval
milliseconds
min_rx
milliseconds
multiplier
role [active |
passive]
Defaults See Parameters
Command Modes INTERFACE
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
– displays the BFD neighbor information on all interfaces or a specified
(OPTIONAL) Enter the keyword disable to disable BFD on this
interface.
(OPTIONAL) Enter the keywords interval to specify non-default
BFD session parameters beginning with the transmission interval. The
range is 50 to 1000. The default is 100.
Enter the keywords min_rx to specify the minimum rate at which
the local system would like to receive control packets from the
remote system. The range is 50 to 1000. The default is 100.
value
Enter the keywords multiplier to specify the number of packets
that must be missed in order to declare a session down. The range is
3 to 50. The default is 3.
Enter the role that the local system assumes:
• Active—The active system initiates the BFD session. Both
systems can be active for the same session.
• Passive—The passive system does not initiate a session. It
only responds to a request for session initialization from the
active system.
The default is Active.
321