File Management; Boot Config - Dell Force10 Z9000 Reference Manual

File Management

This chapter contains command line interface (CLI) commands needed to manage the configuration files as well as
other file management commands.
The commands in this chapter are supported by the Dell Force10 operating software (FTOS) on the E-Series, C-Series, S-
Series, Z-Series, S4810 and S4820T platforms.

boot config

Set the location and name of the configuration file that is loaded at system start-up (or reload) instead of the default
startup-configuration.
C-Series, E-Series
Syntax boot config {remote-first | rpm0 file-url | rpm1 file-url}
Parameters
remote-first
rpm0
rpm1
file-url
Defaults Not configured
Command Modes CONFIGURATION
Command History
Version 7.5.1.0
E-Series
Usage To display these changes in the show bootvar command output, save the running
Information
configuration to the startup configuration (copy running-config startup-config
or write).
Enter the keywords remote-first to attempt to load the boot
configuration files from a remote location.
Enter the keywords rpm0 first to specify the local boot configuration
file for route processor module (RPM) 0.
Enter the keywords rpm1 first to specify the local boot configuration
file for RPM 1.
Enter the location information:
• For a file on the internal Flash, enter flash:// followed by
the filename.
• For a file on the external Flash, enter slot0:// followed by
the filename.
Introduced on C-Series
Original command
3
57