Ip Control-Plane Egress-Filter; Show Ip Accounting Access-List - Dell Force10 Z9000 Reference Manual

Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage You can assign one ACL (standard or extended ACL) to an interface.
Information
When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the CPUs and
soft-forwarded, if required, in the following scenarios:
Related
ip access-list standard
Commands
ip access-list extended

ip control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.
Z-Series, S4810
Syntax ip control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1

show ip accounting access-list

Display the IP access-lists created on the switch and the sequence of filters.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip accounting {access-list access-list-name | cam_count}
interface interface
Parameters
access-list-name
cam_count
interface
interface
216
Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: This command supports Loopback interfaces EE3 and EF series route processor
modules (RPMs). This command does not support Loopback interfaces ED series RPMs, C-
Series or S-Series Loopback interfaces.
• on a Layer 2 interface - if a Layer 3 ACL is applied to the interface
• on a Layer 3 port or on a Layer 2/Layer 3 port
– configures a standard ACL.
– configures an extended ACL.
Introduced on the Z9000.
Enter the name of the ACL to be displayed.
List the count of the CAM rules for this ACL.
Enter the keyword interface followed by the one of the following
keywords and slot/port or number information: