Dell Force10 Z9000 Reference Manual page 252

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

Enter the IP address of the network or host from which the packets

Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,

when specified in A.B.C.D format, may be either contiguous or non-

Enter the keyword any to specify that all routes are subject to the

Enter the keyword host and then enter the IP address to specify a

host IP address.

Enter the keyword dscp to deny a packet based on the DSCP value.

The range is 0 to 63.

(OPTIONAL) Enter one of the following logical operand:

Enter the application layer port number. Enter two port numbers if you

are using the range logical operand. The range is 0 to 65535.

Enter the IP address of the network or host to which the packets are

(OPTIONAL) Enter the keyword count to count packets processed

by the filter.

(OPTIONAL) Enter the keyword byte to count bytes processed by

(OPTIONAL, E-Series only) Enter the keyword log to have the

information kept in an ACL log file.

(OPTIONAL) Enter the keyword order to specify the QoS priority for

the ACL entry. The range is 0 to 254 (where 0 is the highest priority

and 254 is the lowest; lower order numbers have a higher priority). If

you do not use the keyword order, the ACLs have the lowest order

by default (255).

(OPTIONAL) Enter the keyword monitor when the rule is describing

the traffic that you want to monitor and the ACL in which you are

creating the rule is applied to the monitored interface.

NOTE: For more information, refer to the Flow-based Monitoring

section in the Port Monitoring chapter of the

Enter the keyword fragments to use ACLs to control packet

eq = equal to

neq = not equal to

gt = greater than

lt = less than

range = inclusive range of ports (you must specify two ports

for the port parameter)

FTOS Configuration