Dell Force10 Z9000 Reference Manual page 229

any
vlan
ip-address
opcode
number
count
byte
log
order
monitor
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.2.1.0
Version 8.1.1.0
Version 7.4.1.0
Version 6.5.1.0
Usage
The order option is relevant in the context of the Policy QoS feature only. For more
Information
information, refer to the Quality of Service chapter of the
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Enter the keyword any to match and drop any ARP traffic on the
interface.
vlan-id
Enter the keyword vlan and then enter the VLAN ID to filter traffic
associated with a specific VLAN. The range is 1 to 4094 and 1 to 2094
for ExaScale ( you can use IDs 1 to 4094). To filter all VLAN traffic,
specify VLAN 1.
Enter an IP address in dotted decimal format (A.B.C.D) as the target
IP address of the ARP.
code-
Enter the keyword opcode and then enter the number of the ARP
opcode. The range is 1 to 23.
(OPTIONAL) Enter the keyword count to count packets processed
by the filter.
(OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
(OPTIONAL, E-Series only) Enter the keyword log to have the
information kept in an ACL log file.
(OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower order numbers have a higher priority) If
you did not use the keyword order, the ACLs have the lowest order
by default (255).
(OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface. For more
information, refer to the section "Flow-based Monitoring" in the Port
Monitoring chapter of the
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on the E-Series ExaScale.
Added support for the non-contiguous mask and added the
monitor option.
Expanded to include the optional QoS order priority for the ACL
entry.
FTOS Configuration Guide .
FTOS Configuration Guide .
229