Debug Frrp - Dell Force10 Z9000 Reference Manual

Version 7.5.1.0
Usage Executing this command without the optional ring-id command clears the statistics
Information
counters on all the available rings. FTOS requires a command line confirmation before the
command executes. This commands clears the following counters:
Example
FTOS#clear frrp
Clear frrp statistics counter on all ring [confirm] yes
FTOS#clear frrp 4
Clear frrp statistics counter for ring 4 [confirm] yes
FTOS#
Related show frrp
Commands

debug frrp

Clear the FRRP statistics counters.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax debug frrp {event | packet | detail} [ring-id] [count number]
To disable debugging, use the no debug frrp {event | packet | detail}
{ring-id} [countnumber] command.
Parameters
event
packet
detail
ring-id
count
Defaults Disabled.
Command Modes CONFIGURATION (conf-frrp)
640
Introduced.
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
– displays the Resilient Ring Protocol configuration.
Enter the keyword event to display debug information related to ring
protocol transitions.
Enter the keyword packet to display brief debug information related
to control packets.
Enter the keyword detail to display detailed debug information
related to the entire ring protocol packets.
(Optional) Enter the ring identification number. The range is 1 to 255.
number
Enter the keyword count followed by the number of debug outputs.
The range is 1 to 65534.