Spanning Tree Mode - Dell Force10 Z9000 Reference Manual

AS-PATH ACL Mode
You must use AS-PATH ACL mode to configure an AS-PATH Access Control List (ACL) on the E-Series. For more
information, refer to Access Control Lists
To enter AS-PATH ACL mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip as-path access-list command. Include a name for the AS-PATH ACL. The prompt changes
to include (config-as-path).
You can return to CONFIGURATION mode by using the exit command.
IP COMMUNITY LIST Mode
You must use IP COMMUNITY LIST mode to configure an IP Community ACL on the E-Series. For more information, refer
to Access Control Lists (ACL).
To enter IP COMMUNITY LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip community-list command. Include a name for the Community list. The prompt changes to
include (config-community-list).
You can return to CONFIGURATION mode by using the exit command.
REDIRECT-LIST Mode
You must use REDIRECT-LIST mode to configure a Redirect list on the E-Series. For more information, refer to the
Series FTOS Command Line Reference Guide , Policy-based Routing (PBR).
To enter REDIRECT-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the ip redirect-list command. Include a name for the Redirect-list. The prompt changes to include
(conf-redirect-list).
You can return to CONFIGURATION mode by using the exit command.

SPANNING TREE Mode

You must use SPANNING TREE mode to enable and configure the Spanning Tree protocol. For more information, refer to
Spanning Tree Protocol (STP).
To enter SPANNING TREE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree
You can return to CONFIGURATION mode by using the exit command
(ACL).
stp-id command.
E-
53