Line Mode - Dell Force10 Z9000 Reference Manual

Prompt Interface Type
FTOS(conf-if)# INTERFACE mode
FTOS(conf-if- Gigabit Ethernet interface followed by the slot/port information
gi-0/0)#
FTOS(conf-if- Ten-Gigabit Ethernet interface followed by slot/port information
te-0/0)#
FTOS(conf-if- Forty-Gigabit Ethernet interface followed by slot/port information
fo-0/0)#
FTOS(conf-if- Loopback interface number
lo-0)#
FTOS(conf-if- Null Interface followed by zero
nu-0)#
FTOS(conf-if- Port-channel interface number
po-0)#
FTOS(conf-if- VLAN Interface followed by VLAN number (range 1–4094)
vl-0)#
FTOS(conf-if- SONET interface followed by slot/port information
so-0/0)#
FTOS(conf-if- Management Ethernet interface followed by slot/port information
ma-0/0)#
FTOS(conf-if- Designated interface range (used for bulk configuration).
range)#

LINE Mode

You must use LINE mode to configure the console or virtual terminal parameters.
To enter LINE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the line command. Include the keywords console or vty and their line number available on the switch.
The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the exit command.
TRACE-LIST Mode
You must use TRACE-LIST mode to configure a Trace list.
To enter TRACE-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip trace-list command. Include the name of the Trace list. The prompt changes to include (conf-
trace-acl).
You can exit this mode by using the exit command.
51