Show Ip Pim Sparse-Mode Nexthop - Allied Telesis x310-26FT Command Reference Manual

PIM-SM C
OMMANDS
-
SHOW IP PIM SPARSE MODE NEXTHOP

show ip pim sparse-mode nexthop

Overview Use this command to see the next hop information as used by PIM-SM.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax show ip pim sparse-mode nexthop
Mode User Exec and Privileged Exec
awplus#
Example
Figure 30-10: Example output from the show ip pim sparse-mode nexthop
Flags: N = New, R = RP, S = Source, U = Unreachable 
Destination Type Nexthop Nexthop Nexthop
Num
____________________________________________________________________________
10.10.0.9 .RS.
Table 2: Parameters in output of the show ip pim sparse-mode nexthop
C613-50103-01 REV A
show ip pim sparse-mode nexthop
command
Addr
1 0.0.0.0 4
command
Parameter Description
Destination
The destination address for which PIM-SM requires next hop
information.
Type
The type of destination, as indicated by the Flags description. N =
New, R= RP, S = Source, U = Unreachable.
Nexthop Num
The number of next hops to the destination. PIM-SM always uses
only 1 next hop.
Nexthop Addr
The address of the primary next hop gateway.
Nexthop
The interface on which the next hop gateway can be reached.
IfIndex
Nexthop Name
The name of next hop interface.
Metric
The metric of the route towards the destination.
Preference
The preference of the route towards destination.
Refcnt
Only used for debugging.
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Nexthop Metric Pref
Name 
Ifindex
0 0
"Getting Started
Guide.
Refcnt
1 
1255