Ntp-H158 Install The Electrical Cables - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 1 Install the Cisco ONS 15310-MA SDH
Complete the
Step 4
enable UDC circuits. A UDC circuit allows you to create a dedicated data channel between nodes.
Step 5 Complete the
task on page 18-58
Step 6 Continue with the
Stop. You have completed this procedure.

NTP-H158 Install the Electrical Cables

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. For
Caution
detailed instructions on how to wear the ESD wristband, refer to the
(ESD) and Grounding
Note The 64-pin champ cables (E1) and 75 ohm coax cables (E3) configurations are different for OSP
installations. For information about OSP installation, refer to the installation manual provided with the
OSP cabinet.
To carry electrical traffic on the ONS 15310-MA SDH, you must install electrical cables.
Note
Step 1 Complete the
Step 2 Complete the
Complete the
Step 3
Complete the
Step 4
Stop. You have completed this procedure.
78-19416-01
"DLP-H256 Install the UDC Cable on the ONS 15310-MA SDH" task on page 18-58
"DLP-H257 Install the LAN Cable for the CTC Interface on the ONS 15310-MA SDH"
to provide access to the CTC graphical user interface (GUI).
"NTP-H158 Install the Electrical Cables" procedure on page
This procedure describes how to install the electrical E1 (64-pin Champ)
and DS3/E3 (coaxial) cables.
Shielded coaxial cable terminated with BNC connectors for DS3/E3 ports
64-pin Champ connector terminated to shielded, twisted-pair cable
NTP-H157 Install Wires to Alarm, Timing, Craft, LAN, and UDC Pin
Connections, page 1-26
As needed
Onsite
None
Guide.
"DLP-H258 Install CHAMP Cables for E1 Connection" task on page 18-59
"DLP-H259 Install DS-3/E3 Cables" task on page 18-62
"DLP-H260 Route Cables" task on page 18-63
"NTP-H159 Install and Remove SFPs" procedure on page
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Required Tools and Equipment
1-27.
Cisco ONS Electrostatic Discharge
as needed.
as needed.
1-28.
to
as needed.
1-27