Dlp-H72 View Alarms - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
In the Circuit Source area, complete the following:
Step 6
•
•
•
•
Click Next.
Step 7
In the Circuit Destination area, complete the following:
Step 8
•
•
•
•
Step 9 Click Finish.
Step 10 Put the ports that are hosting the IP-encapsulated tunnel in service. See the
Service State for a Port" task on page 16-67
Return to your originating procedure (NTP).
Step 11

DLP-H72 View Alarms

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the card, node, or network view, click the Alarms tab to view the alarms for that card, node, or
Step 1
network.
Table 16-5
Table 16-5
Column
Num
Ref
New
Date
78-19416-01
Node—Choose the source node.
Slot—Choose the source slot.
Port—If displayed, choose the source port.
Channel—Displays IPT (D1-D3).
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.
Channel—Displays IPT (D1-D3).
This task views current alarms on a card, node, or network.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
describes the columns in the Alarms window.
Alarm Column Descriptions
Information Recorded
Sequence number of the original alarm
Reference number of the original alarm
Indicates a new alarm; to change this status, click either the Synchronize button or
the Delete Cleared Alarms button.
Date and time of the alarm.
for instructions.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
"DLP-H50 Change the
16-87