Ntp-H114 View The Loopback Status On A Port - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
As needed, complete the
Step 2
page
Step 3 As needed, complete the
page
Step 4 As needed, complete the
page
As needed, complete the
Step 5
page
Stop. You have completed this procedure.

NTP-H114 View the Loopback Status on a Port

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
loopback status. If you are already logged in, continue with
In node view, double-click the card where you want to view the loopback status on a port. The card view
Step 2
displays.
Depending on the port where the loopback is located, click one of the following tab sequences:
Step 3
•
•
•
•
The Number (#) and Service State columns identify the port number and current operating state
(In-Service and Normal [unlocked-enabled]; Out-of-Service and Management, Maintenance
[locked-enabled,maintenance]; and Out-of-Service and Management, Disabled
[locked-enabled,disabled]) of each port on the card. The Loopback Type column identifies the type of
loopback (None, Terminal, or Facility) applied to each port on the card.
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
14-14
"DLP-H218 Soft-Reset a 15310E-CTX-K9 Card Using CTC" task on
18-15.
"DLP-H219 Hard-Reset the 15310E-CTX-K9 Card Using CTC" task on
18-16.
"DLP-H220 Soft-Reset an Ethernet or Electrical Card Using CTC" task on
18-17.
"DLP-H221 Hard-Reset an Ethernet or Electrical Card Using CTC" task on
18-18.
"DLP-H29 Log into CTC" task on page 16-43
Maintenance > E1 > Loopback
Maintenance > DS3 > Loopback
Maintenance > E3 > Loopback
Maintenance > Optical > Loopback
Use this task to view the loopback status on a selected ports.
None
None
As needed
Onsite or remote
Retrieve or higher
Chapter 14
at the node where you want to view the
Step 2.
Maintain the Node
78-19416-01