Initiate A Card Or Port Lock On Command; Initiate A Card Or Port Lock Out Command; Clear A Card Or Port Lock On Or Lock Out Command - Cisco ONS 15600 SDH Troubleshooting Manual

Chapter 2 Alarm Troubleshooting
In the Switching Commands area, click Clear.
Step 4
Click Yes in the Confirmation Dialog box.
Step 5
The Force switch is cleared. Traffic immediately reverts to the working port if the group was configured
for revertive switching.

Initiate a Card or Port Lock On Command

For a 1+1 optical protection group, only the working port can be placed in the Lock On state.
Note
In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups list, click the protection group where you want to apply a lock-on.
Step 2
If you determine that the protect card is in standby mode and you want to apply the lock-on to the protect
Step 3
card, make the protect card active if necessary by completing the following steps:
a.
b.
In the Selected Group list, click the active card where you want to lock traffic.
Step 4
In the Inhibit Switching area, click Lock On.
Step 5
Click Yes in the confirmation dialog box.
Step 6

Initiate a Card or Port Lock Out Command

Note For a 1+1 optical protection group, only the protect port can be placed in the Lock Out state.
Step 1 In node view, click the Maintenance > Protection tabs.
In the Protection Groups list, click the protection group that contains the card you want to lock out.
Step 2
In the Selected Group list, click the card that you want to lock traffic out of.
Step 3
In the Inhibit Switching area, click Lock Out.
Step 4
Click Yes in the confirmation dialog box.
Step 5
The lockout has been applied and traffic is switched to the opposite card.

Clear a Card or Port Lock On or Lock Out Command

In node view, click the Maintenance > Protection tabs.
Step 1
In the Protection Groups list, click the protection group that contains the card that you want to clear.
Step 2
July 2010
In the Selected Group list, click the protect card.
In the Switch Commands area, click Force.
2.8.2 Protection Switching, Lock Initiation, and Clearing
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-125