Verify Card Led Operation; Verify G-Series Ethernet Or Fc_Mr-4 Card Led Operation - Cisco ONS 15454 Troubleshooting Manual

Chapter 1 General Troubleshooting
Table 1-47 Lamp Test for Optical and Electrical Card LEDs
Possible Problem
Faulty optical and
electrical port LED

Verify Card LED Operation

In CTC, click the Maintenance > Diagnostic tabs.
Step 1
Click Lamp Test.
Step 2
Watch to make sure all the port LEDs illuminate as previously noted for several seconds.
Step 3
Click OK on the Lamp Test Run dialog box.
Step 4
With the exceptions previously described, if an OC-N or DS-N LED does not light up, the LED is faulty.
Return the defective card to Cisco through the RMA process. Contact Cisco TAC (1 800 553-2447).
Symptom
properly.
Table 1-48
Note G-Series and FC_MR-4 card-level LEDs illuminate during a lamp test, but the port-level LEDs do not.
Table 1-48 Lamp Test for G-Series or FC_MR-4 Card LEDs
Possible Problem
Faulty LED

Verify G-Series Ethernet or FC_MR-4 Card LED Operation

Step 1 Complete the
operational.
Step 2 Use the following list of guidelines to physically test whether the G-Series Ethernet port LEDs are
operating correctly. If the LED appears as described when the listed state is occurring for the port, the
LED is considered to be functioning correctly.
•
•
November 2004
Solution
A lamp test verifies that all the port LEDs work. Run this diagnostic test as
part of the initial ONS 15454 turn-up, a periodic maintenance routine, or any
time you question whether an LED is in working order.
Complete the
G-Series Ethernet or FC_MR-4 card LED does not light, or you are unsure if LEDs are working
describes the possible problem and the solution for G-Series and FC_MR-4 cards.
Solution
Complete the
procedure on page
"Verify Card LED Operation" procedure on page 1-105
Clear port LED: Should only occur if there is a loss of receive link (such as a disconnected link or
unplugged GBIC). An LOS alarm could be present on the port.
Amber port LED: Should only occur if a port is disabled but the link is connected; or if the port is
enabled and the link is connected, but a transport failure is present. A TPTFAIL alarm can be present
on the port.
"Verify Card LED Operation" procedure on page
"Verify G-Series Ethernet or FC_MR-4 Card LED Operation"
1-105.
Cisco ONS 15454 Troubleshooting Guide, R4.6
1.11.3 Lamp Tests for Card LEDs
1-105.
to verify that card-level LEDs are
1-105