Dlp-H233 Change Line And Threshold Settings For E1 Ports - Cisco ONS 15310-MA SDH Procedure Manual

Click the Provisioning > Server Trails tabs.
Step 2
Click the server trail that you want to delete.
Step 3
Click Delete.
Step 4
In the confirmation dialog box, click Yes.
Step 5
You can use the server trail audit log to recreate a server trail that you may have accidentally deleted.
Note
The server trail audit log includes the following parameters:
•
•
•
•
•
•
•
You can look at the audit log of the source or destination node and find the entry for the delete call. This
log entry has the VC4/VC3 path definitions on the node, peer IP address, and server trail ID. You can
then look at the audit log of the peer IP address, locate the delete call for the specific server trail ID, and
find the VC4/VC3 path definitions on the node. This would provide you with the required information
to recreate the server trail.
Note It is recommended that you delete one server trail at a time as the deletion of multiple trails together may
cause CTC to hang and is a time consuming task.
Step 6 Return to your originating procedure (NTP).

DLP-H233 Change Line and Threshold Settings for E1 Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Refer to the "Network Element Defaults" appendix in the Cisco ONS 15310-MA SDH Reference Manual
Note
for E1 port default settings.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-32
Server trail ID
Peer IP address
Circuit size
Protection type
Number of trails
Starting VC4/VC3
SRLG value
This task changes line and threshold settings for E1 ports on the
E1_21_E3_DS3_3 and E1_63_E3_DS3_3 cards.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 18 DLPs H200 to H299
78-19416-01