Dlp-B123 View Electrical Pm Parameters - Cisco ONS 15327 Procedure Manual

Chapter 7 Monitor Performance

DLP-B123 View Electrical PM Parameters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click an XTC card. The card view appears.
Step 1
Step 2 Click the Performance tab
Figure 7-4
Card View
Performance
radio buttons
Directions
radio buttons
Click the DS1 or DS3 tab to view the desired PM parameters.
Step 3
The PM parameter names appear on the left portion of the window in the Param column. The PM values
appear on the right portion of the window in the Curr (current), and Prev-n (previous) columns. For PM
parameter definitions, refer to the Cisco ONS 15327 Reference Manual.
Return to your originating procedure (NTP).
Step 4
March 2003
(Figure
Viewing Electrical Performance Monitoring Information
DS1 tab
DS3 tab
Refresh
Port
Intervals
This task enables you to view DS-1 or DS-3 PM counts on a selected
XTC card to detect possible performance problems.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve or higher
7-4).
Auto-refresh
NTP-B195 Monitor Electrical or Optical Performance
Baseline Clear
Cisco ONS 15327 Procedure Guide, R4.0
7-7