Dlp-B166 Change Line And Threshold Settings For The Ds-3 Ports; Table 10-4 Vt1.5 Path Thresholds Options For Ds-1 Ports - Cisco ONS 15327 Procedure Manual

NTP-B88 Modify Line Settings and PM Parameter Thresholds for Electrical Ports

Table 10-4 VT1.5 Path Thresholds Options for DS-1 ports

Parameter
Port #
CV
ES
FC
SES
UAS
Note
Return to your originating procedure (NTP).
Step 7

DLP-B166 Change Line and Threshold Settings for the DS-3 Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15327 Procedure Guide, R4.0
10-6
Description
DS-1 ports partitioned for STS
Coding violations
Errored seconds
Failure count
Severely errored seconds
Unavailable seconds
The threshold value displays after the circuit is created.
This task changes the line and threshold settings for the DS-3 ports. The
default DS-3 values are listed in
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Chapter 10
Options
Read-only
Line 1, STS 1, Line 2, STS 1
Line 3, STS 1, Line 4 STS 1
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click the Refresh button (Near End, STS
termination).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click the Refresh button (Near End, STS
termination).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click the Refresh button (Near End, STS
termination).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click the Refresh button (Near End, STS
termination).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click the Refresh button (Near End, STS
termination).
Table C-2 on page C-7.
Change Port Settings
March 2003