Port Address Name Assignment - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Configuring FICON Ports
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Prohibit configurations are always symmetrically applied—if you prohibit Port 0 from talking to port 15,
port 15 is automatically prohibited from talking to port 0.
If an interface is already configured in E or TE mode and you try to prohibit that port, your prohibit
Note
configuration is rejected. Similarly, if a port is not up and you prohibit that port, the port is not allowed
to come up in E mode nor in TE mode.
To prohibit port addresses in a VSAN, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ficon vsan 2
switch(config-ficon)#
Step 3
switch(config-ficon)# portaddress 7
switch(config-ficon-portaddr)#
Step 4
switch(config-ficon-portaddr)# prohibit portaddress 3-5
switch(config-ficon-portaddr)# no prohibit portaddress 5

Port Address Name Assignment

To assign a port address name, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ficon vsan 2
switch(config-ficon)#
Step 3
switch(config-ficon)# portaddress 7
switch(config-ficon-portaddr)#
Step 4
switch(config-ficon-portaddr)# name SampleName
switch(config-ficon-portaddr)# no name SampleName
Cisco MDS 9000 Family Configuration Guide
24-22
Chapter 24
Purpose
Enters configuration mode.
Enables FICON on VSAN 2.
Selects port address 7 for further
configuration.
Prohibits port address 7 in VSAN 2
from talking to ports 3, 4, and 5.
Removes port address 5 from a
previously prohibited state.
Purpose
Enters configuration mode.
Enables FICON on VSAN 2.
Selects port address 7 for further
configuration.
Assigns a name to the port address.
The port address name is restricted
Note
to 24 alphanumeric characters.
Deletes a previously configured port
address name.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Configuring FICON