Dlp-H56 Assign A Name To A Port; Dlp-H57 Provision Path Protection Selectors During Circuit Creation - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99

DLP-H56 Assign a Name to a Port

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Double-click the card that has the port you want to provision.
Step 1
Click the Provisioning tab.
Step 2
Complete the following, as necessary:
Step 3
•
•
•
•
•
Step 4 Click the Port Name column for the port number you are assigning a name to and enter the desired port
name.
The port name can be up to 32 alphanumeric/special characters and is blank by default.
Step 5 Click Apply.
Step 6 Return to your originating procedure (NTP).

DLP-H57 Provision Path Protection Selectors During Circuit Creation

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
78-19416-01
This task assigns a name to a port on any ONS 15310-MA SDH card.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
For 15310-MA-CTX E1 ports, click the E1 subtab.
For 15310-MA-CTX DS-3 ports, click the DS3 subtab.
For 15310-MA-CTX E3 ports, click the E3 subtab.
For 15310-MA-CTX STM-M ports, click the Optical subtab.
For CE-100T-8, CE-MR-6, or ML-100T-8 cards, click the Ether Ports or POS Ports subtab.
This task provisions path protection selectors during circuit creation.
Complete this task only if the circuit will be routed on a path protection
configuration.
None
DLP-H29 Log into CTC, page 16-43
The Circuit Creation wizard Circuit Attributes page must be open.
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-75