Dlp-H121 Provision Path Trace On Circuit Source And Destination Ports - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 17 DLPs H100 to H199

DLP-H121 Provision Path Trace on Circuit Source and Destination Ports

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This task assumes you are setting up path trace on a bidirectional circuit and setting up transmit strings
Note
at the circuit source and destination.
From the View menu, choose Go to Network View.
Step 1
Click the Circuits tab.
Step 2
For the VC high/low-order path circuit you want to monitor, verify that the source and destination ports
are on a card that can transmit and receive the path trace string.
SDH cards and/or ports that support J1 and/or J2 path trace.
Table 17-6
Trace Function
Transmit and receive
Receive
Step 3 If neither port is transmit/receive, you will not be able to complete this task. If one port is
transmit/receive and the other is a receive-only port, you can set up the transmit string at the
transmit/receive port and the receive string at the receive-only port, but you will not be able to transmit
in both directions.
Choose the VC high-order path circuit you want to trace, then double-click it (or click Edit).
Step 4
If you chose a VCAT circuit, complete the following. If not, continue with
Step 5
a.
b.
Step 6 In the Edit Circuit window, click the Show Detailed Map check box at the bottom of the window. A
detailed map of the source and destination ports appears.
78-19416-01
This task creates a path trace on VC3/VC4 order path circuit source ports
and destination ports.
Cards capable of transmitting and receiving path trace must be installed at
the circuit source and destination. See
of cards.
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
ONS 15310-MA SDH Cards/Ports Capable of J1/J2 Path Trace
J1 or J2
J1
J1 and J2
J2
J1
In the Edit Circuit window, click the Members tab.
Click Edit Member and continue with
Cards/Ports
ML-100T-8
CE-MR-6
CE-100T-8
ONS 15310-MA SDH STM-M and E1 ports
ONS 15310-MA SDH STM-M, E3, E1, and DS3
ports
Step 6.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Table 17-6 on page 17-27
Table 17-6 shows the ONS 15310-MA
Step 6.
for a list
17-27