Figure 5-1 Setting Circuit Attributes For A Ds-1 Circuit - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 5
Create Circuits and VT Tunnels
Figure 5-1
If the circuit will be routed on a path protection, complete the
Step 6
Selectors During Circuit Creation" task on page
Click Next.
Step 7
Complete the
Step 8
In the Circuit Routing Preferences area
Step 9
available; choose either, both, or none based on your preferences.
Using Required Nodes/Spans—Check this check box if you want to specify nodes and spans to
•
include or exclude in the CTC-generated circuit route.
Review Route Before Creation—Check this check box if you want to review and edit the circuit
•
route before the circuit is created.
Set the circuit path protection:
Step 10
To route the circuit on a protected path, leave Fully Protected Path checked and continue with
•
Step
Fully-protected paths may or may not have path protection path segments (with primary and
alternate paths), and the path diversity options apply only to path protection path segments, if any
exist.
To create an unprotected circuit, uncheck Fully Protected Path and continue with
•
To route the circuit on a BLSR protection channel, if available, uncheck Fully Protected Path,
•
check Protection Channel Access, click Yes on the Warning dialog box, and then continue with
Step
Caution
Circuits routed on BLSR protection channels are not protected. They are preempted during BLSR
switches.
Step 11
If you selected Fully Protected Path in
•
Nodal Diversity Required—Ensures that the primary and alternate paths within path protection
portions of the complete circuit path are nodally diverse.
•
Nodal Diversity Desired—Specifies that node diversity is preferred, but if node diversity is not
possible, CTC creates fiber-diverse paths for the path protection portion of the complete circuit path.
March 2003
Setting Circuit Attributes For a DS-1 Circuit
"DLP-B95 Provision a DS-1 Circuit Source and Destination" task on page
11. CTC creates a fully-protected circuit route based on the path diversity option you choose.
13.
NTP-B181 Create an Automatically Routed DS-1 Circuit
"DLP-B218 Provision Path Protection
5-27. Otherwise, continue with the next step.
(Figure
5-2), click Route Automatically. Two options are
Step
10, choose one of the following:
Cisco ONS 15327 Procedure Guide, R4.0
5-17.
Step
13.
5-7
Advertisement
Table of Contents
