Dlp-B212 Create A User Data Channel; Figure 5-13 Provisioning A Dcc Tunnel - Cisco ONS 15327 Procedure Manual

Chapter 5 Create Circuits and VT Tunnels

Figure 5-13 Provisioning a DCC Tunnel

Click OK.
Step 4
Put the ports that are hosting the DCC tunnel in service. See the
Step 5
for a Port" task on page 4-6
Return to your originating procedure (NTP).
Step 6

DLP-B212 Create a User Data Channel

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In network view, click the Provisioning > Overhead Circuits tabs.
Step 1
Click Create.
Step 2
Step 3 In the Circuit Creation dialog box, complete the following fields:
•
•
In the Endpoints area, choose the source and destination nodes and the source and destination optical
Step 4
ports and slots from the drop-down menus.
Step 5 Click Finish.
Return to your originating procedure (NTP).
Step 6
March 2003
for instructions.
This task creates a user data channel (UDC) on the ONS 15327. A UDC
circuit allows you to create a dedicated data channel between nodes.
None
NTP-B24 Verify Card Installation, page 3-2
DLP-B60 Log into CTC, page 2-23
As needed.
Onsite or remote
Provisioning or higher
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
Type—Choose either User Data-F1 or User Data D-4-D-12 from the drop-down menu.
NTP-B194 Create Overhead Circuits
"DLP-B214 Change the Service State
Cisco ONS 15327 Procedure Guide, R4.0
5-81