Dlp-H68 Create A User Data Channel Circuit - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
Step 6 In the Circuit Destination area, complete the following:
•
•
•
•
Click Finish.
Step 7
Put the ports that are hosting the DCC tunnel in service. See the
Step 8
a Port" task on page 16-67
Return to your originating procedure (NTP).
Step 9

DLP-H68 Create a User Data Channel Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In network view, click the Provisioning > Overhead Circuits tabs.
Step 1
Click Create.
Step 2
Step 3 In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:
•
•
Click Next.
Step 4
78-19416-01
DCC options do not appear if they are being used by the ONS 15310-MA SDH (DCC1) or other
tunnels.
Node—Choose the destination node.
Slot—Choose the destination slot.
Port—If displayed, choose the destination port.
Channel—These options appear if you chose DCC Tunnel-D1-D3 as the tunnel type. Choose one of
the following:
DCC1 (D1-D3)—Section DCC
–
DCC2 (D4-D6)—Line DCC 1
–
DCC3 (D7-D9)—Line DCC 2
–
DCC4 (D10-D12)—Line DCC 3
–
DCC options do not appear if they are used by the ONS 15310-MA SDH (DCC1) or other tunnels.
for instructions.
This task creates a user data channel (UDC) circuit on the ONS 15310-MA
SDH. A UDC circuit allows you to create a dedicated data channel between
nodes.
None
DLP-H12 Install the UDC Cable on the ONS 15310-MA SDH, page 16-13
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
Type—Choose either User Data-F1 or User Data D-4-D-12 from the drop-down list. In the
Endpoints area, choose the source and destination nodes and the source and destination STM-M
ports and slots from the drop-down lists.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
"DLP-H50 Change the Service State for
16-85