Dlp-H202 Add A Static Tid To Nsap Entry To The Tarp Data Cache; Dlp-H203 Remove A Static Tid To Nsap Entry From The Tarp Data Cache - Cisco ONS 15310-MA SDH Procedure Manual

Click Apply.
Step 3
Return to your originating procedure (NTP).
Step 4

DLP-H202 Add a Static TID to NSAP Entry to the TARP Data Cache

Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 1
Click Add Static Entry.
Step 2
In the Add Static Entry dialog box, enter the following:
Step 3
•
•
Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the
Step 4
Add Static Entry dialog box.
Return to your originating procedure (NTP).
Step 5

DLP-H203 Remove a Static TID to NSAP Entry from the TARP Data Cache

Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-4
Timers T1, T2, and T4 are not used if TARP PDUs Origination is not enabled.
Note
This task adds a static TID to NSAP entry to the TDC. The static entries are
required for NEs that do not support TARP and are similar to static routes.
For a specific TID, you must force a specific NSAP.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioner or higher
TID—Enter the TID of the NE. (For ONS nodes, the TID is the Node Name parameter on the node
view Provisioning > General tab.)
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
This task removes a static TID to NSAP entry from the Tarp Data Cache
(TDC).
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioner or higher
Chapter 18 DLPs H200 to H299
78-19416-01