Dlp-H99 Enable Intermediate-Path Performance Monitoring - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H99 Enable Intermediate-Path Performance Monitoring

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The monitored IPPM parameters are VC high-order path CV-P, VC high-order path ES-P, VC high-order
Note
path SES-P, VC high-order path UAS-P, and VC high-order path FC-P. For more information about
IPPM parameters, refer to the "Performance Monitoring" chapter in the Cisco ONS 15310-MA SDH
Reference Manual.
Step 1 In node view, double-click the 15310E-CTX-K9 card. The card view appears.
Step 2 Click the Provisioning > Optical > SDH VC high-order path tabs.
Step 3 Check the check box in the Enable IPPM column for the VC high-order path you want to monitor.
Click Apply.
Step 4
Click the Performance tab to view PM parameters. For IPPM parameter definitions, refer to the
Step 5
"Performance Monitoring" chapter in the Cisco ONS 15310-MA SDH Reference Manual.
Step 6 Return to your originating procedure (NTP).
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-116
This task enables intermediate-path performance monitoring (IPPM),
which allows you to monitor large amounts of VC high-order path traffic
through intermediate nodes. This task also enables IIPM VC low-order
path in the ONS 15310-MA SDH.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 16 DLPs H1 to H99
78-19416-01