Provision A Dcc Tunnel; Figure 6-16 Selecting Dcc Tunnel End Points - Cisco ONS 15327 User Documentation

Creating DCC Tunnels
Procedure: Provision a DCC Tunnel
Log into an ONS 15327 that is connected to the non-ONS 15327 network.
Step 1
Click the Provisioning > Sonet DCC tabs.
Step 2
Beneath the DCC Tunnel Connections area (bottom right of the screen), click Create.
Step 3
In the Create DCC Tunnel Connection dialog box
Step 4
From (A) and To (B) lists.
Note

Figure 6-16 Selecting DCC tunnel end points

Click OK.
Step 5
Put the ports hosting the DCC tunnel in service:
Step 6
a.
b.
c.
d.
DCC provisioning is now complete for one node. Repeat these steps for all slots/ports that are part of the
DCC tunnel, including any intermediate nodes that will pass traffic from third-party equipment. The
procedure is confirmed when the third-party network elements successfully communicate over the
newly-established DCC tunnel.
Cisco ONS 15327 User Documentation, R3.3
6-22
You cannot use the SDCC listed under SDCC Terminations (left side of the window) for
tunnel connections. These are used for ONS 15327 optical connections.
Double-click the card hosting the DCC in the shelf graphic or right-click the card on the shelf
graphic and select Open.
Click the Provisioning > Line tabs.
Under Status, select In Service.
Click Apply.
Chapter 6
(Figure 6-16), select the tunnel end points from the
Circuits and Tunnels
June 2002