Dlp-B320 Delete A Card - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
NTP-B219 Remove and Replace a Card
Onsite/Remote
Security Level
If you are not logged into CTC and you need to remove a card, remove the card as described in
Step 1
When you log into CTC, troubleshoot the mismatched equipment (MEA) alarm with the Cisco ONS
15327 Troubleshooting Guide.
If you are logged into CTC, either:
Step 2
•
•
Physically remove the card:
Step 3
a.
b.
Step 4
Insert the new card using one of the following procedures as applicable:
•
•
Stop. You have completed this procedure.
DLP-B320 Delete a Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
On the shelf graphic, right-click the card that you want to remove and choose Delete Card.
Step 1
You cannot delete a card if any of the following conditions apply:
•
•
•
•
•
•
Cisco ONS 15327 Procedure Guide, R4.0
1-26
Onsite
Provisioning or higher
Complete the
"DLP-B320 Delete a Card" task on page 1-26
Complete the
"DLP-B247 Change an Optical Card" task on page 1-27
it with a different optical card while maintaining existing provisioning.
Open the card latches/ejectors.
Use the latches/ejectors to pull the card forward and away from the shelf.
NTP-B217 Install the XTCs, page 1-21
NTP-B218 Install the Optical and Ethernet Cards, page 1-23
This task deletes a card from CTC.
None
DLP-B60 Log into CTC, page 2-23
As needed
Both
Provisioning or higher
The card is one of two installed XTC cards (a default XTC protection group was created); to replace
an XTC card, refer to the Replace Hardware chapter in the Cisco ONS 15454 Troubleshooting Guide
The card is part of a protection group; see
The card has circuits; see
The card is part of a bidirectional line switched ring (BLSR); see
page 13-9
The card is being used for timing; see
The card has a SONET DCC termination; see
NTP-B204 Delete a SONET DCC Termination, page 9-14
DLP-B155 Delete a Protection Group, page 9-14
NTP-B152 Delete Circuits, page 8-15
DLP-B157 Change the Node Timing Source, page 9-15
Chapter 1
Install Hardware
and continue with
Step 3
or
to delete a card and replace
NTP-B213 Remove a BLSR Node,
Step
3.
March 2003
Advertisement
Table of Contents
