Ntp-H134 Reset Cards Using Ctc - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 14 Maintain the Node
Figure 14-3
If you replace the door, be sure to reattach the ground strap.
Step 10
Stop. You have completed this procedure. Estimated time of replacement by a skilled technician:
two minutes.

NTP-H134 Reset Cards Using CTC

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Do not soft reset more than one ONS 15310-MA SDH card at a time. Instead, issue a soft reset command
for a single card, then wait until CTC shows that the card is initialized. You can then issue a soft reset
on another card if needed. Completing soft resets in sequence helps to avoid unexpected traffic hits.
Complete the
Step 1
software reset. If you are already logged in, continue with Step 2.
78-19416-01
Installing the Fan-Tray Assembly
This procedure resets a 15310E-CTX-K9, electrical, or Ethernet card
using soft and hard resets. A soft reset reboots the card and reloads the
operating system and the application software. A hard reset temporarily
removes power from the card and clears all buffer memory before it is
physically reseated.
None
Card installation procedure(s)
As needed
Onsite or remote
Maintenance or higher
"DLP-H29 Log into CTC" task on page 16-43
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
at the node where you are performing the
14-13