Reset Button; Power Supply - Cisco 1000 Series Hardware Installation Manual

Reset Button

LED
LTE DATA/SIM
(C1101-4PLTEPWz
C1 101-4PL TEP/C1 101-4PL TEPWx)
WLAN
(C1101-4PLTEPWx)
USB console
USB 3.0
Reset Button
The actuation of the Reset button is only recognized during ROMmon boot, that is, as the router comes to the
ROMmon prompt.
The Reset button does not require much force to be pressed. The Reset button should be pressed only with a
small implement such as the tip of a pen or a paper clip. When the Reset button is pressed at startup, the system
LED turns green.
For more information, see the "Reset Overview" section of the

Power Supply

• AC input voltage: Universal 100 to 240 VAC
• Frequency: 50 to 60 Hz
• Maximum output power: Up to 66W for non-PoE supply and upto 150W for PoE supply
• Optional PoE and PoE+
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
20
Color Description
Green and Amber Single LTE modem (one
modem with SIM
switch-over capability)
Off: Modem not up or
modem up and no SIM
Amber steady on:
Modem up, SIM installed
but not active.
Green Blink: LTE data
activity.
3-color LED: Green, Red WLAN functions
and Amber;
Green USB console status
OFF: USB console not
active
ON: USB console active
Green USB 3.0 status
OFF: No USB device
discovered
ON: USB device
discovered
USB activity
Overview of Cisco 1000 Series Integrated Services Routers
Control Source
Bezel side
I/O
I/O
I/O
Cisco 1100 Software Configuration Guide.