Change Port Settings
This chapter explains how to change transmission settings on electrical and optical ports in a
Cisco ONS 15327.
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15327 Troubleshooting Guide as necessary.
Changing card or port settings can be service affecting. You should make all changes during a scheduled
Caution
maintenance window.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
NTP-B88 Modify Line Settings and PM Parameter Thresholds for
Electrical Ports
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
March 2003
NTP-B88 Modify Line Settings and PM Parameter Thresholds for Electrical Ports, page
10-1—Complete as needed.
NTP-B89 Modify Line Settings and PM Parameter Thresholds for Optical Ports, page
10-9—Complete as needed.
This procedure changes the line and threshold settings for electrical ports;
default values are listed in the
page
None
As needed
Onsite or remote
Provisioning or higher
"Card Default Settings" section on
C-4.
Cisco ONS 15327 Procedure Guide, R4.0
C H A P T E R
10
10-1