Ntp-H61 Enable, Modify, Or Disable Alarm Severity Filtering; Ntp-H62 Suppress Alarms Or Discontinue Alarm Suppression - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 8 Manage Alarms

NTP-H61 Enable, Modify, or Disable Alarm Severity Filtering

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step
As necessary, complete the
Step 2
filtering at the card, node, and network views for all nodes in the network. Alarm filtering can be enabled
for alarms or conditions.
Step 3 As necessary, complete the
page 16-103
conditions.
As necessary, complete the
Step 4
profile filtering for all network nodes.
Stop. You have completed this procedure.

NTP-H62 Suppress Alarms or Discontinue Alarm Suppression

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step
Complete the
Step 2
autonomous messages that clear specific raised alarms and cause suppressed alarms to appear in the
Conditions window.
78-19416-01
This procedure starts, changes, or stops alarm filtering for one or more
severities in the Alarms, Conditions, and History windows in all network
nodes.
None
As needed
Onsite or remote
Retrieve or higher
"DLP-H29 Log into CTC" task on page
2.
"DLP-H84 Enable Alarm Filtering" task on page 16-102
"DLP-H85 Modify Alarm and Condition Filtering Parameters" task on
to modify the alarm filtering for network nodes to show or hide particular alarms or
"DLP-H88 Disable Alarm Filtering" task on page 16-107
This procedure prevents alarms from being reported for a port, card, or
node in circumstances when an alarm or condition is known to exist but
you do not want to include it in the Alarms or History display. This
procedure also resumes normal alarm reporting by discontinuing the
suppression.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page
2.
"DLP-H86 Suppress Alarm Reporting" task on page 16-105
16-43. If you are already logged in, continue with
16-43. If you are already logged in, continue with
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
to enable alarm
to disable alarm
to enable the node to send
8-7