Ntp-L14 Attaching Wires To Alarm, Timing, Lan, And Craft Pin Connections - Cisco NCS 2006 Hardware Installation Manual

Connecting and Routing the Cables
NTP-L14 Attaching Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Always use the supplied ESD wristband when working with a powered NCS 2006. For detailed instructions
Caution
on how to wear the ESD wristband, see the
2000
Procedure
Step 1 Complete
Step 2 Complete
external timing in .
Step 3 Complete
timing in ETSI.
Step 4
Complete
Table 12: PIDs for SCSI Cables
Cable
SCSI alarm cable
SCSI alarm patch cable
SCSI alarm wire-wrap
cable
Series.
DLP-L26 Installing Alarm Wires in NCS 2006, on page 230
DLP-L27 Installing Timing Wires on NCS 2006 - ANSI, on page 235
DLP-L28 Installing Timing Wires in NCS 2006 - ETSI, on page 237
DLP-L29 Installing LAN Wires in NCS 2006, on page 240
PID
15454-M-ALMCBL=
15454-M-AEXPCBL=
15454-M-ALMCBL2=

NTP-L14 Attaching Wires to Alarm, Timing, LAN, and Craft Pin Connections

Use this procedure to attach alarm, timing, LAN, and
craft wires in the NCS 2006 shelf.
Twisted #22 or #24 AWG (0.51 mm² or 0.64 mm²)
shielded wires for LAN or craft 75-ohm coaxial cable
with DIN-1.0/2.3 miniature coaxial connector, Alarm
26 pins SCSI cable.
NTP-L8 Install the NCS 2006 ECU and ECU-S
Modules, on page 277
As needed
Onsite
None
Electrostatic Discharge and Grounding Guide for Cisco NCS
Length
20 Meter
1 Meter
20 Meter
Cisco NCS 2000 Series Hardware Installation Guide
if you are provisioning external alarms.
if you are provisioning
if you are provisioning external
to create an external LAN connection.
Wire Dimension
28 AWG
28 AWG
24 AWG
229