Measuring And Limiting Traffic With The Traffic Meter - Cisco ISA500 Series Administration Manual

Device Management

Measuring and Limiting Traffic with the Traffic Meter

STEP 5
STEP 6
Measuring and Limiting Traffic with the Traffic Meter
STEP 1
STEP 2
Cisco ISA500 Series Integrated Security Appliance Administrator Guide
To send the compressed file for system diagnosis, you first need to
NOTE
enable the Debug Support Alert feature and configure the email
account settings in the Email Alert Setting page. Click the link or go
to the Device Management -> Email Alert Settings page to do this.
See Configuring the Email Alert Settings, page
Click Save to apply your settings.
Click Send Now to send the compressed file to the specified email address
immediately.
Traffic Meter allows you to measure and limit the traffic routed by the security
appliance. You can enable the traffic meter settings for both primary WAN and
secondary WAN (if applicable).
Click Device Management -> Traffic Meter -> Primary WAN Settings.
The Primary WAN Settings window opens.
To configure the traffic meter settings for the secondary WAN if applicable,
NOTE
click Device Management -> Traffic Meter -> Secondary WAN Settings.
In the Enable Traffic Meter area, enter the following information:
• Enable Traffic Metering: Click On to enable the traffic metering on the
primary WAN port, or click Off to disable it. Enabling this feature on the
primary port will keep a record of the volume of traffic going from this
interface.
• Traffic Limit Type: Specify the restriction on the volume of data being
transferred through the primary WAN port.
- No Limit: The default option, where no limits on data transfer are
imposed.
10
316.
328