Toyota Tundra 2005 Service - Repair - Maintenance page 3538

INSTALLATION
Butt Weld
— 14
— 1
1. Before temporarily installing the new parts, apply
body sealer to the reinforcement, side impact protec-
tion beam and back side of the new parts.
HINT:
1) Apply just enough sealer for the reinforcement and
side impact beam to touch the new panel. Apply sealer
evenly around the flange area, about 10 mm (0.39 in.)
from the edge, as shown.
2) For other sealing points, refer to section AR.
BODY PANEL REPLACEMENT
Butt Weld
— 7
— 1
Body Sealer
— 4
about 10 mm
30_
— 5
2. Bend the flange hem about 30_ with a hammer and
dolly, then fasten tightly with a hemming tool.
HINT:
1) Perform hemming in three steps, being careful not to
warp the panel.
2) If a hemming tool cannot be used hem with a hammer
and dolly.
RE-21
Body Sealer
Do not close the
drain hole.
Cloth Tape
Hemming Tool
mm in.
10 0.39