Network - Dell C9000 Series Reference Manual

Usage Information When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor
routers are possible.
To ensure that only specific interfaces are receiving and sending data, use the
passive-interface command with the neighbor command.
Related passive-interface
Commands

network

Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this
command.
C9000 Series
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address
Defaults No RIP network is configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
— sets the interface to only listen to RIP broadcasts.
Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Routing Information Protocol (RIP) 1898