Usage Information The default route must be present in the switch routing table for the default-
information originate command to take effect.
default-metric
Change the default metric for routes. To ensure that all redistributed routes use the same metric value, use
this command with the redistribute command.
C9000 Series
Syntax
default-metric number
To return the default metric to the original values, use the no default-metric
command.
Parameters
number
Defaults
1
Command Modes
ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Usage Information This command ensures that route information being redistributed is converted to the
same metric value.
Related
redistribute
Commands
Specify a number. The range is from 1 to 16. The default is 1.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— allows you to redistribute routes learned by other methods.
Routing Information Protocol (RIP)
1887