Passive-Interface - Dell C9000 Series Reference Manual

Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Usage Information This command is intended for low-speed interfaces.

passive-interface

Suppress routing updates on a specified interface.
C9000 Series
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface
command.
Parameters
interface
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the following information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 4096.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1
to 4094.
Routing Information Protocol (RIP) 1901