Offset-List - Dell C9000 Series Reference Manual

Version
6.2.1.1
Usage Information You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the network command
specifies.

offset-list

Specify a number to add to the incoming or outgoing route metrics learned using RIP.
C9000 Series
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in | out}
offset [interface] command.
Parameters
prefix-list-name
offset
interface
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Description
Introduced on the E-Series.
Enter the name of an established Prefix list to determine which
incoming routes are modified.
Enter a number from zero (0) to 16 to be applied to the
incoming route metric matching the access list specified. If you
set an offset value to zero (0), no action is taken.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1
to 4094.
Routing Information Protocol (RIP) 1899