Ip Rip Send Version - Dell C9000 Series Reference Manual

Version
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Usage Information If you want the interface to receive both versions of RIP, use the ip rip receive
version 1 2 command.
Related

ip rip send version

Commands
version
ip rip send version
To send a specific version of RIP, set the interface. The version you set on the interface overrides the version
command in ROUTER RIP mode.
C9000 Series
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1
2
Defaults RIPv1
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the RIP version for sending RIP traffic on an interface.
— sets the RIP version the switch software uses.
(OPTIONAL) Enter the number 1 for RIP version 1. The default is
RIPv1.
(OPTIONAL) Enter the number 2 for RIP version 2.
Description
Introduced on the C9010.
Routing Information Protocol (RIP) 1894